hi boys
I have been trying to install archlabs on h.d. for two days external from 2 ter, but the boot does not appear on the laptop, does anyone know why?
The installation is all correct and there are both fat and .ext4 partitions.
This is the first time this has happened to me in 15 years.
Thank for help
sdc 8:32 0 1,8T 0 disk
├─sdc1 8:33 0 512M 0 part
└─sdc2 8:34 0 1,8T 0 part
sr0 11:0 1 1024M 0 rom
Modello: WD Elements 2621 (scsi)
Disco /dev/sdc: 2000GB
Dimensione del settore (logica/fisica): 512B/512B
Tabella delle partizioni: gpt
Flag del disco:
Numero Inizio Fine Dimensione File system Nome Flag
1 1049kB 538MB 537MB fat32 ESP avvio, esp
2 538MB 2000GB 2000GB ext4 ArchLabs
I have disabled secure boot in the bios, do I need to enable it?
Yet with other hard disks they work with secure boot disabled, and with gpt partitions, they are only smaller in size, I can’t understand where the problem is
With this external hard drive there is no booting.
When I press f9 it should boot systemd-boot but it is not there.
last night i got the new seagate from 1 T, i installed in gpt-uefi and everything w
ent smoothly.
And that hard drive problem and it’s 6 months old.
I realized that there was something strange, when I did the clone with gparted of the fat32 / boot and / root of any distro both arch linux and archlabs, when I booted from that hard disk the boot did not appear.
In your opinion, it is possible that the problem lies in the size of the sector.
I say this because the seagate has this dimension:
Modello: Seagate Expansion (scsi)
Disco /dev/sdb: 1000GB
Sector size (logical / physical): 512B/4096B
Tabella delle partizioni: gpt
Flag del disco:
Numero Inizio Fine Dimensione File system Nome Flag
1 1049kB 636MB 635MB fat32 avvio, esp
2 636MB 26,6GB 26,0GB ext4
3 26,6GB 27,5GB 918MB fat32 avvio, esp
4 27,5GB 44,9GB 17,3GB ext4